Baystate Jeepers

Greetings All -

I've got a '96 Chherokee and the lower control arm bracket has torn off the axle. I'm goint to buy some replacement brackets online but I'm not confident I can use my little Lincold wire-feed welder to repair these so can anyone recommend a welder/repair shop near Danvers? TIA - Dan

A 110 volt welder turned up will zap those mounts on with ease. Practice on some scrap and save a buck.

Every cage piece or frame repair on my Heep has been done with either a gasless MIG or stick. I've even welded a couple of things with two batteries just for giggles.

Don't forget to stop by the intro thread and say hello as well.

thanks for encouragement - maybe I'll give it a try.