Greetings All -
I've got a '96 Chherokee and the lower control arm bracket has torn off the axle. I'm goint to buy some replacement brackets online but I'm not confident I can use my little Lincold wire-feed welder to repair these so can anyone recommend a welder/repair shop near Danvers? TIA - Dan
Suggestions for a shop near Danvers
-
ZAEDOCK
- BSJ Member
- Posts: 2428
- Joined: Fri Jan 01, 2010 11:18 am
- Jeep Year: 1992
- Jeep Model: YJ Wrangler
Re: Suggestions for a shop near Danvers
A 110 volt welder turned up will zap those mounts on with ease. Practice on some scrap and save a buck.
Every cage piece or frame repair on my Heep has been done with either a gasless MIG or stick. I've even welded a couple of things with two batteries just for giggles.
Don't forget to stop by the intro thread and say hello as well.
Every cage piece or frame repair on my Heep has been done with either a gasless MIG or stick. I've even welded a couple of things with two batteries just for giggles.
Don't forget to stop by the intro thread and say hello as well.
Last edited by ZAEDOCK on Tue Sep 07, 2010 4:43 pm, edited 1 time in total.
BSJ President 2003 - 2005Carl McFly wrote:X2, I agree with Joe. And not just because he's man candy
-
DJRJR
- BSJ 101 Planning Commitee
- Posts: 3
- Joined: Tue Sep 07, 2010 8:41 am
- Jeep Year: 1996
- Jeep Model: XJ Cherokee
Re: Suggestions for a shop near Danvers
thanks for encouragement - maybe I'll give it a try.