Baystate Jeepers

Posted: **Sat Aug 24, 2019 1:01 pm**

Should I have a some protective armor welded around it? Or should I cut a hole in my bumper and move it up inside? Any advice would be appreciated!

Posted: **Sat Aug 24, 2019 1:34 pm**

Make it a pigtail that you can disconnect when not in use. If you are towing while wheeling, route it above the bumper.

Posted: **Sat Aug 24, 2019 5:45 pm**

Thats what I did. I have pig tail that it up out of the way...

Posted: **Sat Aug 24, 2019 6:27 pm**

Thanks!

Posted: **Wed Aug 28, 2019 1:16 pm**

I figured it out. The bracket is installed per Mopar instructions, with just two hex screws. And the connector itself has a 7-pin pigtail that is easy to disconnect.

(the other valve is my bumper water tank spigot)

Posted: **Wed Aug 28, 2019 2:38 pm**

I hope you have a weather cover for the pig tail. Also get a small tube of dielectric grease to push into every connection FjR68

Posted: **Wed Aug 28, 2019 5:56 pm**

Good advice. Thanks!

Baystate Jeepers

How do I keep my trailer connector from getting smashed?

How do I keep my trailer connector from getting smashed?

Re: How do I keep my trailer connector from getting smashed?

Re: How do I keep my trailer connector from getting smashed?

Re: How do I keep my trailer connector from getting smashed?

Re: How do I keep my trailer connector from getting smashed?

Re: How do I keep my trailer connector from getting smashed?

Re: How do I keep my trailer connector from getting smashed?