Page 1 of 1
replacing HP D30 yoke toque?
Posted: Sat Jun 15, 2019 9:20 pm
by ChrisD
It has been so long since I have wrenched on the jeep and I can't remember the torque spec replacing a yoke for an HP D30. I could pull the carrier and go the hard route, but I have to imagine there is an easier route?
Does 210 FT LB sound correct?
Re: replacing HP D30 yoke toque?
Posted: Mon Jun 17, 2019 8:12 pm
by ChrisD
Anyone?
Re: replacing HP D30 yoke toque?
Posted: Mon Jun 17, 2019 9:05 pm
by BlackNBlue-ISH
My cheat sheet of torque values has "???" as axle Yoke Nut torque. At the transfer case it's 110-120 ftlbs.
If I recall, you may not be far off though.
Re: replacing HP D30 yoke toque?
Posted: Mon Jun 17, 2019 9:10 pm
by BlackNBlue-ISH
For the TJ D30 (low pinion) per the service manual, the pinion nut torque spec is 160-200 ft lbs.
Re: replacing HP D30 yoke toque?
Posted: Mon Jun 17, 2019 9:31 pm
by MDSRACING398
Just re read you said hp30. If reusing nut couple drops of red lock tight 180 will do you fine.
Re: replacing HP D30 yoke toque?
Posted: Mon Jun 17, 2019 10:53 pm
by ChrisD
Big thanks!
Re: replacing HP D30 yoke toque?
Posted: Wed Jun 19, 2019 5:34 am
by Frank
I thought the big difference was one had a crush sleeve , not to be reused and the other had bearing and shims. That would be the biggest torque difference between the two. FjR68
Re: replacing HP D30 yoke toque?
Posted: Wed Jun 19, 2019 6:48 pm
by nhdcoye
Frank wrote:I thought the big difference was one had a crush sleeve , not to be reused and the other had bearing and shims. That would be the biggest torque difference between the two. FjR68
Actually I thought the Dana 30 could not take any torque
