Baystate Jeepers

What Did You Do To Your Jeep Today?

Thought we had one of these threads going a while ago… There’s always someone doing something so post up!

Replaced the front drivers unit bearing yesterday which was starting to get some play. Drove it to work today and couldn't tell it was any better than the usual jeep ride

Absolutely nothing the past few weeks.
Hope to wheel it this weekend though at Harris Mtn for one of the last few remaining opportunities this season.
Not a BSJ event

Another 70 miles.

Drove it to work.

The other one, slowly working on tearing apart the new Ford 8.8 axle... motivation & life gets in the way...

Put it back in the barn finally.

I slowly and gently slid my hand along her fine lines from one end to another . It was GOOD ! FjR68

Frank wrote:I slowly and gently slid my hand along her fine lines from one end to another . It was GOOD ! FjR68

The ‘J’ stands for ‘Jeep’ not ‘Jeans’

I replaced tie rod and steering stabilizer and got an alignment done. did not fix the problem

Ran an errand, parked the jeep only to find this critter staring me down. Not sure if he was looking to bite me or steal the jeep. It showed no fear or concern

Tonight I swapped the coolant in the Cherokee. It was straight water with some rust remover chemical, now it’s a proper mix. Going on day 11 running well enough. That’s 4 days past my last prediction. Still waiting for the next failure.

Finally got around to installing the Tatton front driveshaft. Looks good! And then I discovered a flat tire and leaking front axle seal.

Got the shop cleaned up and ready for the winter upgrades planned. Won't bore you with details. I posted them up once in a different thread. Going to be a good winter!

Finally got the front axle truss welded back on and the axle back in! Now to try and get it inspected before the end of the month...

Dude Try using the high lift on those fenders . Putem back where they belong. Your axle goes in vertical ? Thats different FjR68