Page 1 of 1
Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 2:12 pm
by ASauer17
What? Has anyone ever failed state inspection for their STOCK fog light being out? Not the head lights... but a fog light?
(my light is somewhat broken-- you need to bang on it to work).
Re: Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 2:57 pm
by MDSRACING398
Any light on vehicle whether stock or aftermarket add-on needs to work (that is if want be dicks) just take them off
Re: Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 4:43 pm
by Marky
Or fix it. Successful percussive maintenance usually indicates a bad connection near where you're hitting. Check any connections and make sure the bulb is seated properly.
Re: Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 4:51 pm
by ASauer17
I could remove, but i like fogs! Connection to the actual fog is good. Replaced bulb and that did nothing.. I wonder if it's the housing unit
Re: Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 5:39 pm
by Marky
There could be an internal connection. Can you disassemble the housing?
Re: Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 8:00 pm
by MDSRACING398
All I'm saying is take fogs off get sticker put back on. If need sticker immediately. Usually fog lights ground through housing see if have good ground point.
Re: Failed State Inspection- stock fog not working
Posted: Fri Aug 25, 2017 8:10 pm
by ASauer17
Piece of rust bucket!
Housing crumble. Haha. Ha.. Haha.. I'll try again with only 1 fog!
Re: Failed State Inspection- stock fog not working
Posted: Sun Aug 27, 2017 7:06 am
by Frank
You will only half fail ! FjR68