Baystate Jeepers

Ready for the next wrenchfest. This one will be mostly all electrical type stuff.

Install dual battery box
Install Painless accessory control pack
Wire up winch
Install CB system (if time)

The rear lights and rocker lights will most likely still need to be tied into the system later but if we are able to get everything done in the engine bay wiring them in later should be easy. Wrenchfest after this one will be for skid plates so while the Jeep is in the air for that the other wiring can be run.

Date thinking April 30th or May 1st
Location since we don't really need a lift or anything we can do this at our house or any other location if someone has one to suggest. Jen and I do not mind traveling.

Thanks

schwalby wrote:...Date thinking April 31st...

Only 30 days in April Josh man

I'm available to help out 4/30 or 5/1.

I think there should be 31.

Post corrected.

schwalby wrote:Ready for the next wrenchfest. This one will be mostly all electrical type stuff.

Install dual battery box
Install Painless accessory control pack
Wire up winch
Install CB system (if time)

The rear lights and rocker lights will most likely still need to be tied into the system later but if we are able to get everything done in the engine bay wiring them in later should be easy. Wrenchfest after this one will be for skid plates so while the Jeep is in the air for that the other wiring can be run.

Date thinking April 31st or May 1st
Location since we don't really need a lift or anything we can do this at our house or any other location if someone has one to suggest. Jen and I do not mind traveling.

Thanks

schwalby wrote:I think there should be 31.

Post corrected.

That's odd. I'm still seeing it as April 31.

RalphTomaccio wrote:That's odd. I'm still seeing it as April 31.

Fixed..