Page 1 of 1
06 TJ header
Posted: Sat May 10, 2014 6:19 pm
by Frank
I just installed a banks header on a 06 TJ. Now when you start it ,l its WFO only. Throttle plate is closed. Ran fine to my house. Any ideas ??? Thanks FjR68
Re: 06 TJ header
Posted: Sat May 10, 2014 7:52 pm
by Frank
It has codes now PO123
PO108
PO113 All I did was put a freekin header on. Its got to be an air leak , Yes ? FjR68
Re: 06 TJ header
Posted: Sun May 11, 2014 7:29 am
by mrfreakinwhite
p0123 = Throttle position sensor
Everything points to a vacuum leak at the intake, yes.
Re: 06 TJ header
Posted: Sun May 11, 2014 8:03 pm
by Carl McFly
Frank wrote:I just installed a banks header on a 06 TJ
ummmm that TJ...... it's not the same TJ that needed the exhaust manifold, you remember, the one I picked up for you and said I'd hold it for you?
Re: 06 TJ header
Posted: Mon May 12, 2014 7:11 am
by Kurt
High RPM's usually points to an air leak.
Re: 06 TJ header
Posted: Mon May 12, 2014 7:17 am
by Frank
Carl : That one is for my 4.0 head on my 4.2 block. Was an air leak and I waited till morning with daylight to look things over. Missed the front ,tiny little,almost to small to do any good , locating pin for the intake. The new one suck to work on ! Ill have you know. FjR68