Page 1 of 1
uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 3:11 pm
by ChrisD
The recent SYE kit and drive shaft did not come with the extra 4 uJoint bolts needed to finish the install. Besides Lou's where can I buy these, just the bolts (m8 1.0)??
Re: uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 4:29 pm
by SidewaysTim
Dealer?
Re: uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 5:11 pm
by Frank
Most any parts stores that carry U-joints . If your yoke is the type that the bolts go all the way through then you need to buy a washer for each and use lock nuts also ! FjR68
Re: uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 6:51 pm
by johnsxj
Most CV driveshafts use SAE 5/16" fine thread bolts. Any decent autoparts store should have what you need (reduced head with a shoulder)
For the short term, pull your front driveshaft and steal the bolts at the t-case yoke to mount up the rear!
Re: uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 7:08 pm
by nostaw
I'm surprised they didn't come w/ the DS. Make sure you get grade 8 if you buy them at a local store... A "good" hardware store may have them, or possibly a good auto parts store. The dealer may not because the fixed yoke isn't OE.
JW
Re: uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 7:12 pm
by johnsxj
Ask for front bolts at the dealer.
Re: uJoint bolts... where can you get them???
Posted: Thu Mar 18, 2010 7:36 pm
by ChrisD
johnsxj wrote:Ask for front bolts at the dealer.
this is what i did.. 3$ total for 4 of them, will be here tomorrow.