Baystate Jeepers

Had an axle shaft stud that some how become bent. Can I just use a grade 8 bolt to replace or should I just contact the manufacturer for a replacement stud?

You'll need a proper wheel stud to replace the bent one with.
Most any auto parts store should have them.
Just pound the bent one out with a hammer and then put the new one in.
You'll need to use a lug nut and a few washers under it to draw it into the wheel hub.

Kurt these are Superior Axle shafts, that have the threaded holes for the 4.5" or 5" spacing.

Most speed shops should have the screw in studs in different sizes. Usually come in packs of 5.

Oh... didn't know you have fancy schmancy shafts in there - LOL
Assumed you were talking stock shafts

Speed Shops?

Little Napoleon wrote:Speed Shops?

Victory Auto Supply & Speed Shop over in Fitchburg.
Summit Racing
Jeggs
etc.. etc..

Like the Fancy Schmancy ! FjR68

johnsxj wrote:

Little Napoleon wrote:Speed Shops?

Victory Auto Supply & Speed Shop over in Fitchburg.
Summit Racing
Jeggs
etc.. etc..

Thanks!

I usually toss a drop O' red Locktite on mine (Alloy USA screw in's).

I know for a fact summit has them and they sell them induvidually
i only bought one, when i friged one up

bending lug studs??? time for a dana 60!!!

I am a stud.