Page 2 of 2
Re: Figuring out the plumbing :-)
Posted: Tue Feb 26, 2013 10:30 am
by Kurt
Have you seen the back of his Jeep?
It's chocked full too!
He's be lucky to be able to put a "AA" battery back there.
Re: Figuring out the plumbing :-)
Posted: Tue Feb 26, 2013 10:58 am
by schwalby
sounds like you are SOL then. :\
Re: Figuring out the plumbing :-)
Posted: Tue Feb 26, 2013 11:36 am
by ArticRubi
For some reason youngblood still feels like he needs a back seat, I think it must be for his RC car because I've never seen anyone back there
Re: Figuring out the plumbing :-)
Posted: Thu Feb 28, 2013 11:02 am
by mark2215
Re: Figuring out the plumbing :-)
Posted: Fri Mar 01, 2013 9:11 am
by Frank
What kind of air intake is that ? FjR68
Re: Figuring out the plumbing :-)
Posted: Fri Mar 01, 2013 9:27 am
by ArticRubi
He's got a supercharger on there Frankie
Re: Figuring out the plumbing :-)
Posted: Fri Mar 01, 2013 6:47 pm
by Carl McFly
Frank wrote:What kind of air intake is that ? FjR68
the best kind
Re: Figuring out the plumbing :-)
Posted: Sun Mar 03, 2013 9:14 pm
by Kurt
Ryan,
Suggestion....
When you install your assist I'd suggest you leave the draglink disconnected the first time you run the system.
Be sure the hydraulic cylinder in working in the right direction before connecting the draglink.
I found today that somehow the cylinder hoses were reversed eventhough I was sure they were correct.
PS box was trying to steer right and the ram wanted to go left! DOH
Also watch the fluid level and keep topping it off.
Re: Figuring out the plumbing :-)
Posted: Mon Mar 04, 2013 11:45 am
by Baseshakers
Thanks Kurt! I was planning on not tightening the draglink mount yet, so hopefully it will "self-center" to some extent. We'll see! I'm also going to not tighten the belt yet, so I can spin the pump by hand to help prime/bleed the whole system.