My latest breakage

[Captian Carnage]

This time and last time was to much flex Wont happen agian
This is my pinion shaft I finally got it on vid this happened at Boulder bash
When I do something its all right or all wrong NO GRAY AREA LMAO

[Kurt]

Yikes.... That's fugly!


Kinda looks my front pinion after last years beating at Moab

[Captian Carnage]

That was 3 years old now I got Alloy USA 5 year warrenty I hope to have a D 60 in by next year I found 1 Great price
hydro assist + high steer knuckles and 1 ton steering set up for a YJ I hope no 1 buys it before me

[Carl McFly]

OMG BRIAN!!!

that from trying to run with the buggies?

[Captian Carnage]

OMG BRIAN!!!

that from trying to run with the buggies?

Check the NERR ( New England Rock Racing ) at Cheshire fair grounds on the 17th of July I want that win

I did it at Boulder Bash At Cheshire fair Grounds To much flex in front My ca was straight up+ down LOL My 36 in tire dropped in a hole about 4 feet deep I had the BEST time at that point in my class Then bang the pinion let go I got lifted off the rock pile Just put my roll cage in the day before It held the jeep in the air good test for it LOL

[Frank]

Im thinkin there was a little bouncing going on B . I dont think angle is the cause . If the driveshaft bound up the U-joint would bust. Poor mesh or bouncing, not that your hard on your stuff ! FjR68

[Captian Carnage]

Im thinkin there was a little bouncing going on B . I dont think angle is the cause . If the driveshaft bound up the U-joint would bust. Poor mesh or bouncing, not that your hard on your stuff ! FjR68

No much bouncing just putting the passenger tire into a 4 foot hole the 3rd time I stomped on it to get out My control arm was pointed straight down It went Bang LMAO Oh Well The Ft DS is 3 feet long it took the angle put the stress on the pinion
Check out this my Front axle that has a life time warranty Snapped off in the diff The vid is my normal vid not good Almost made the Buggie Buster 1 st try 4 ft high rocks and 2 foot holes on the other side had something to do with it

[Frank]

Looks like the pinion was set to deep . The end is still there and the middle is gone. My guess. FjR68

[Captian Carnage]

Looks like the pinion was set to deep . The end is still there and the middle is gone. My guess. FjR68

On most of it all the teeth are gone After 3 years of what I put it through If it was a Low pinion axle it would of took the ring gear out 1st
Both are close to 30% stronger than stock the next thing is the pinion shaft Stock Hey its only a D 30 and 36in tires Something has to break LOL