Cooling systems...

User avatar
BlackNBlue-ISH
BSJ Member
Posts: 1824
Joined: Mon Mar 24, 2014 12:25 pm
Jeep Year: 2005
Jeep Model: TJ Wrangler
Real Name: Daniel or "ish"
Location: Manchester, NH

Cooling systems...

Unread post by BlackNBlue-ISH »

I've got a 4.0L 98 Cherokee with an overheating issue. The head was just decked and a new gasket was put in. Fluids were filled and air removed from the system best I can figure. I used a funnel that replaces the radiator cap so I can keep the level of fluid well above the highest point within the engine and let it run and draw the fluid from the funnel as air moves through the radiator. Once the level stopped moving and the engine was warm, I shut it off leaving the funnel with fluid still attached and made sure the level never went down so air never entered the system. Once it stopped moving, I plugged the funnel, removed it and replaced the radiator cap.

I can run the engine for 5-10 minutes and the needle doesn't move from just over 210 on the gauge. Then seemingly randomly it jumps to the red and I shut it down. Over flow bottle is nearly full and there doesn't seem to be any leaks, and there isn't any clouds behind the jeep.

Thoughts?
2005 TJ, built and beat accordingly
User avatar
MDSRACING398
BSJ 101 Planning Commitee
Posts: 3294
Joined: Fri Feb 12, 2016 10:24 pm
Jeep Year: 1985
Jeep Model: CJ7
Real Name: Mark

Re: Cooling systems...

Unread post by MDSRACING398 »

Fan running? Thermostat in right way. There is a fan relay under the passenger side headlight [atleast on grand cherokee] that is known to go bad. If jeep has a/c turn it on, it automatically turns on fan that way so you don't need to overheat it to find out.
Last edited by MDSRACING398 on Sun Apr 09, 2017 7:32 pm, edited 1 time in total.
Do it right the first time!
Second place is First Loser! Work Harder
Semper Fi
User avatar
pirahnah3
BSJ Member
Posts: 1318
Joined: Mon Jun 27, 2016 9:26 pm
Jeep Year: 1997
Jeep Model: TJ Wrangler
Real Name: Jim

Re: Cooling systems...

Unread post by pirahnah3 »

Def agree on the fan, and double checking the T-Stat, I know most fail open now to avoid that problem but prob not all do that. Also, is the temp sensor operating correctly? might be worth checking around with a temp gun and see if things are that temp or if its bad.
'97 thats been chopped up and put back together, and ready to take on the trails.
User avatar
BlackNBlue-ISH
BSJ Member
Posts: 1824
Joined: Mon Mar 24, 2014 12:25 pm
Jeep Year: 2005
Jeep Model: TJ Wrangler
Real Name: Daniel or "ish"
Location: Manchester, NH

Re: Cooling systems...

Unread post by BlackNBlue-ISH »

The main fan runs constantly, will need to see if the electrical fan spins up. Neglected to notice that. The thermostat was put in with the spring inside the block, I believe that to be correct but not 100% sure. The last couple times I ran it this eve the radiator cap started spewing fluid before the temp gauge spiked. I shut it off at that point.

I'll check the electrical fan using the AC tomorrow first thing. I've got the day off and can putz around with it a bit in the morning.
2005 TJ, built and beat accordingly
User avatar
pirahnah3
BSJ Member
Posts: 1318
Joined: Mon Jun 27, 2016 9:26 pm
Jeep Year: 1997
Jeep Model: TJ Wrangler
Real Name: Jim

Re: Cooling systems...

Unread post by pirahnah3 »

Also, its worth a check of the clutch on the fan as well to ensure function. Easiest way I have heard of checking it, and laugh all you want but it worked for me, was to take a rolled up newspaper and attempt to stop the fan with it, if the clutch is shot and just kinda spinning the fan but not moving it enough it will stop the fan without problem, if the clutch is good, youll have confetti.
'97 thats been chopped up and put back together, and ready to take on the trails.
Post Reply