06 TJ header
-
Frank
- Frankie BSJ Member
- Posts: 4145
- Joined: Sun Dec 27, 2009 8:54 am
- Jeep Year: 1974
- Jeep Model: CJ5
06 TJ header
I just installed a banks header on a 06 TJ. Now when you start it ,l its WFO only. Throttle plate is closed. Ran fine to my house. Any ideas ??? Thanks FjR68
-
Frank
- Frankie BSJ Member
- Posts: 4145
- Joined: Sun Dec 27, 2009 8:54 am
- Jeep Year: 1974
- Jeep Model: CJ5
Re: 06 TJ header
It has codes now PO123
PO108
PO113 All I did was put a freekin header on. Its got to be an air leak , Yes ? FjR68
PO108
PO113 All I did was put a freekin header on. Its got to be an air leak , Yes ? FjR68
-
mrfreakinwhite
- BSJ 101 Planning Commitee
- Posts: 447
- Joined: Thu Jun 27, 2013 7:15 pm
- Jeep Year: 1998
- Jeep Model: XJ Cherokee
- Location: Lunenburg, MA
Re: 06 TJ header
p0123 = Throttle position sensor
Everything points to a vacuum leak at the intake, yes.
Everything points to a vacuum leak at the intake, yes.
-
Carl McFly
- BSJ Member
- Posts: 2466
- Joined: Wed Dec 23, 2009 11:14 pm
- Jeep Year: 2000
- Jeep Model: TJ Wrangler
- Real Name: Carl
- Location: Medford MA
Re: 06 TJ header
ummmm that TJ...... it's not the same TJ that needed the exhaust manifold, you remember, the one I picked up for you and said I'd hold it for you?Frank wrote:I just installed a banks header on a 06 TJ
"Roads? Where we're going, we don't need roads"
-
Kurt
- BSJ Member
- Posts: 4209
- Joined: Wed Dec 23, 2009 11:53 am
- Jeep Year: 1992
- Jeep Model: YJ Wrangler
- Real Name: Kurt K.
- Location: Pepperell, MA
Re: 06 TJ header
High RPM's usually points to an air leak.
"Build It, Run It, Break It, Improve It, Repeat!"
NEA Treasurer 2016, 2017, 2018, 2019, 2020
BSJ Treasurer 2020
NEA Treasurer 2016, 2017, 2018, 2019, 2020
BSJ Treasurer 2020
-
Frank
- Frankie BSJ Member
- Posts: 4145
- Joined: Sun Dec 27, 2009 8:54 am
- Jeep Year: 1974
- Jeep Model: CJ5
Re: 06 TJ header
Carl : That one is for my 4.0 head on my 4.2 block. Was an air leak and I waited till morning with daylight to look things over. Missed the front ,tiny little,almost to small to do any good , locating pin for the intake. The new one suck to work on ! Ill have you know. FjR68