sheet metal- for TJ

[ASauer17]

OK- I will now look at smaller gauge and cut and replace the hole

I will do some research...

What, no Fall Crawl??

I wanted trail 7 or 8 which was 33" w/ lockers BOTH are closed. So, no fall crawl for me. Instead, I figured I would do this instead

[ASauer17]

So far I have 2 plans!!

cut out the square, trace the cut-out and use that as a template to cut out sheet metal .. and..

1) weld in a new piece
OR
2) cut a piece and rivet in place and use body glue to seal it

Why do I have 2 options? Well, where the wheel well meets the side of the tub is where the rust is. Won't know til I cut her open to see what would make more sense!