Video and Pics from Fall Crawl

[ZAEDOCK]

Here's the bee attack. At 1:25, you'll see them flying around the bottom left near my tire.

Warning: quite a few bad words. Prepare for extreme laughter.





Some pics:

[DOUG]

Pretty funny Joe....

[mopar_power]

had a great time wheeling with you saturday joe even after the broken drive shaft

[Posimoto]

I felt bad you were getting stung Joe but wasn’t much anyone could do however, what the camera didn’t catch was the sprint down the hill followed by high knee pumps while spinning like a top, kinda like an Indian rain dance. =)

[Kurt]

A few pics and 4 video clips for your web wheeling enjoyment

http://s28.photobucket.com/albums/c205/ ... JMovie.mp4

[ASauer17]

[ArticRubi]

Meg, about time to post up some of those 500 pictures you took on the Friday run!

Funny poop Joe!

Only two pictures from me, both from the Sunday run.

Getting tippy:



...and my track bar bracket ripped off the axle tube:



Got off the trail by the grace of Kurt's chain and ratchet straps (what's left of them...) Looks like I got a tow rig just in time, definitely wouldn't be driving home on that! Got a Synergy bracket to replace it, kinda nice, it ships with a couple of tabs to weld on for a ram assist bracket. The ones that come with the PSC kit are more for a generic application, these should make fab work pretty simple.

[ZAEDOCK]

I would have pushed Paul over.

Nice track bar bracket. Would have been fun zapping it with batteries.

[ArticRubi]

I would have pushed Paul over.

Nice track bar bracket. Would have been fun zapping it with batteries.

True. I suck at arc welding. Fact. Paul doing gymnastics on the rocks followed by me snapping off my track bar bracket kinda scared everyone but Kurt and Dave off the trail so it was game over after that. Happened entering the 3rd obstacle on the Lake trail...it was gearing up to be a fun ride too

I inadvertently made the rest of my hydro assist install a bit easier doing it. Since I'm going to just pull the axle to weld the new bracket on, it'll make it easier to replace the steering gear and run the plumbing. Also ditching the crappy electronic sway bar disconnect in lieu of an AntiRock so it should all go a good bit smoother with the axle out of the way.

[DOUG]

A few pics and 4 video clips for your web wheeling enjoyment

http://s28.photobucket.com/albums/c205/ ... JMovie.mp4

Where did you see this guy?

[DOUG]

Damage to my Rig...

[Modeler]

At least you didn't take out Elmer.

[Kurt]

Where did you see this guy?

He was ambling across the camping area near the entrance to the lake trail.
I hopped out and snapped a few pictures of him. He stayed nice and stil while I snapped this one.

[nhdcoye]

Got the pics from the camera uploaded tonight.
Here are a few with more available at: http://s196.photobucket.com/albums/aa24 ... wl%202012/