Wrenchfest - COMPLETED!!!

[beaker]

Battery?

[ASauer17]

AH HA!!! good one..

[Kurt]

AM/FM Radio Antenna..
CB Antenna..

Looking good!!!!!!!!!!!!!!!!!

[ChrisD]

Put a cow bell and some horns on jeep! LOL

[beaker]

Car alarm?
Also probably check the coolant level, though we didn't lose too much from the heater core.

[ASauer17]

Car alarm.. such an annoyance! But, I guess it can be re-installed if all of the wiring is already hooked up.


ps- thanks for all of the reminders! WOO! hopefully I don't have too much "left over" bolts and screws...

[Kurt]

Just remembered... the 4WD transfercase linkage needs to be hooked up

[ZAEDOCK]

Put a cow bell and some horns on jeep! LOL

Cow bells are earned.

[ASauer17]

As some of you have asked via PM, I am not working on the Jeep this weekend. I have/had family events on both Saturday & Sunday.

I go back to work for the first time in 24 days tomorrow. UGH!


The next time I will be heading over there will be on Saturday Jan 14th (which I know there is a run that day..) And Sunday Jan 15.

The goal is to finish by the 15th! Original goal was to make it on the run on the 14th

[ASauer17]

tomorrow I am leaving work early and I am hoping that I can get the new soft top on!

So close!
4WD transfercase linkage
Alarm
AM/FM Radio Antenna
CB Antenna
Remove old Half Door hardware and install new
Fender Flares
Fender inners ( need to pick up more of then xmas tree plastic push pins )

[Carl McFly]

tomorrow I am leaving work early and I am hoping that I can get the new soft top on!

So close!
4WD transfercase linkage
Alarm
AM/FM Radio Antenna
CB Antenna
Remove old Half Door hardware and install new
Fender Flares
Fender inners ( need to pick up more of then xmas tree plastic push pins )

I might be around to help. What time you looking at?


Sent from my iPad using Tapatalk HD

[ASauer17]

I'm leaving Andover at 11. Should be there at 1145am!

[beaker]

The passenger side door kicked my butt yesterday. I tried getting that one screw out. I couldn't weld a nut to it worth a damn. I need to get some cutoff wheels for a dremel & just unscrew it, I think its semi-loose.

-mike

[ASauer17]

those are going to be SO hard to get off.. esp that 1 that got melted.. yarg! I can see if I can borrow a dremel

[ASauer17]

yup.. I'll bring one tomorrow