The jeep is 4wd again!

[Baseshakers]

That is all.

[del_TJ]

Did you finally get your front driveshaft put in?

[Hoodoo Man]

Nice!

[Baseshakers]

more then just the front driveshaft, it took forever to get the new front axle all sorted out. pinion angle, wheelbase, setting the track, trackbar clearance with the truss, alignment, steering stabilizer clearance, exhaust clearance, axle shaft fitment, modifying the knuckles for RCVs, fixing the caliper bolt holes in the knuckle, swapping over the skids, swaybar mounts and shock mounts from my old axle, clearancing the truss brace to the diff, changing out a dead super flex joint, adjusting the bumpstops, and then finally putting in the front DS!

thanks jeff, i hope you get your rig working again soon!

[del_TJ]

Wow, that's a lot of mods to fit the high pinion. That truss looked pretty big though. Are you bringing it out to the BSJ run tomorrow?

[Baseshakers]

yep! headed off to the campground in a few.